Low budget plasma setup, what do I need?

More
7 years 5 months ago #132455 by tecno
Replied by tecno on topic Low budget plasma setup, what do I need?
Thank you Peter for the explanation, appreciated.

Please Log in to join the conversation.

More
7 years 5 months ago #134454 by tecno
Replied by tecno on topic Low budget plasma setup, what do I need?
How do I connect a torch like AG60 / SG55 to my THCAD300?

Please Log in to join the conversation.

More
7 years 5 months ago #134456 by rodw
Replied by rodw on topic Low budget plasma setup, what do I need?

tecno wrote: How do I connect a torch like AG60 / SG55 to my THCAD300?


Its nothing to do with the torch, just connect it to the raw arc voltage

Please Log in to join the conversation.

More
7 years 5 months ago #134457 by tecno
Replied by tecno on topic Low budget plasma setup, what do I need?
Is this at the tip or outgoing connector in chassis?

Please Log in to join the conversation.

More
7 years 5 months ago #134460 by rodw
Replied by rodw on topic Low budget plasma setup, what do I need?
I think I would try and mount it inside your plasma cutter. That way there are no lethal voltages leaving... BUu I think the 5v power supply needs to come from the control box.

Please Log in to join the conversation.

More
7 years 5 months ago #134645 by tommylight
Replied by tommylight on topic Low budget plasma setup, what do I need?
That connection should be made as close as possible to the rectifier inside the plasma cutter, if it has no connector already.

Please Log in to join the conversation.

More
7 years 5 months ago #134687 by tecno
Replied by tecno on topic Low budget plasma setup, what do I need?
Just now I do not know what Plasma cutter I will buy. But 50A will most likely do the jobs at hand and if I need to cut thicker material I will use O/A with Dillon to cut.

Please Log in to join the conversation.

More
7 years 5 months ago #134995 by tecno
Replied by tecno on topic Low budget plasma setup, what do I need?
I am looking at one combined TIG / Plasma that has Piolotarc output, can I connect my THCAD300 to this?

Attachment not found

Please Log in to join the conversation.

More
7 years 5 months ago #135014 by pl7i92
Replied by pl7i92 on topic Low budget plasma setup, what do I need?
Use real tiny Cables you only need the Voltige so no Amps are going over
and keep clear isolated to any other lines

Please Log in to join the conversation.

More
7 years 5 months ago #135017 by tecno
Replied by tecno on topic Low budget plasma setup, what do I need?
Yes that I understand, but does this high-voltage input have sensitivity for for the pilot-arc voltage? I assume the Pilot-arc is already divided down?

Please Log in to join the conversation.

Time to create page: 0.327 seconds
Powered by Kunena Forum