Plasma Torch, first try and lots of questions

CNCFred wrote: Dear all thank you,
I was not sure since they do not even have https on the order pages.

But when you go to checkout, the site swaps over to https: Thats how we used to do it too.
A few years ago it was exceedingly hard to show up as a secure site as one obscure link to a non-SSL site on a https:// site would break your security profile so thats how it was done.

For the last couple of years SSL across your whole site has been a requirement for ranking well on google.

A site refresh to modern ecomm standards could probably allow Mesa to double their sales in 90 days or so but that might scare the daylights out of PCW!

Peter, if your read this and are up for a challenge, touch base with me as I'm currently on this journey and have a kick ass solution that can scale globally.

It was vice versa for me ! secure and not secure on checkout!! At least my browser told me that...
Paypal payment goes to gmail account?
Sorry...I am a suspiciously guy, but due to your recommendation I risked it.

By the way,since stepperonline promised the 4:1 closed are available this week but weren't...I choose the 5:1 precision 23nema and 556, 48 power suplly...
Lets see!
Hope I get some pictures to share soon!

Dear all great thank you, 7i76e arrived today...steppers are stuck in Germany..

Again I am seeking some help.
The card came without manual about the connections, could you kindly provide me a link.

The stepper gears have a
Shaft Diameter: Φ14mm I am searching now Modul1 pijion gears as small as possible.

The cabling of the motors with 2.8A which cable diameter in mm2 do I need to use?

Is linuxcnc on raspi 3 with the 7i76e possible?

Thx a lot!!

CNCFred wrote: Dear all great thank you, 7i76e arrived today...steppers are stuck in Germany..

Again I am seeking some help.
The card came without manual about the connections, could you kindly provide me a link.

The stepper gears have a
Shaft Diameter: Φ14mm I am searching now Modul1 pijion gears as small as possible.

The cabling of the motors with 2.8A which cable diameter in mm2 do I need to use?

Is linuxcnc on raspi 3 with the 7i76e possible?

Thx a lot!!

7i76E Manual

CNCFred wrote: The card came without manual about the connections, could you kindly provide me a link.

Have a look at the attachment here

Cheers, Phill.

Thx, I checked that out already.

Best to know !!

I was looking for exact this!

Since I read the manual of the 556t driver ..does one need the resistors with the 7i76e to limit the current on dir and step?
2k resistors

No, not for the 7I76E's 5V signals
2K is for 24V step/dir signals