My Newb Plasma Table Attempted Build

Ok sorry about the confusion. Hopefully I got it right this time lol. Thanks again for the help Phil, but even more for your patience.

Why are you two up so early?

Because I just finished lunch and mum said never go to bed on a full stomach.

dvn4life1972 wrote: Ok sorry about the confusion. Hopefully I got it right this time lol. Thanks again for the help Phil, but even more for your patience.

No worries, that what we are here for.

Unfortunately that didn't work either, it must be following symlinks.
Open a terminal: Hopefully that will be it...

Edit: Are you using Buidbot or RIP?

Buildbot

tommylight wrote: Why are you two up so early?

It's 11:25pm here. Half a world away from you I reckon.

phillc54 wrote:

dvn4life1972 wrote: Ok sorry about the confusion. Hopefully I got it right this time lol. Thanks again for the help Phil, but even more for your patience.

No worries, that what we are here for.

Unfortunately that didn't work either, it must be following symlinks.
Open a terminal:

Code:

cd linuxcnc/configs tar -czf pats_plasma.zip pats_plasma/

Hopefully that will be it...

Edit: Are you using Buidbot or RIP?

Here goes.

Perfect and it confirms you are using Buildbot.

Did you tell me the version number from the Config Panel?

phillc54 wrote: Perfect and it confirms you are using Buildbot.

Did you tell me the version number from the Config Panel?

Config panel in axis on plasmac?

Yes, next to the buttons at the bottom of the panel.

While you are at it, open a terminal and enter man plasmac and that should have the same version number.