Trouble changing from Gmoccapy to Axis

Sorry - I edited my post but no, the run panel is blank.

Does plasmac_run.hal have any content?

Yes. See attached

OK, for some reason that panel and/or HAL file is not loading.

Edit the INI file and swap the comments.

From:

To:

That did fix it. The run panel is populated and the plasmac_run pins are showing up in Hal Show. I can run it this way - I actually like the run panel to the side better than being a tab.

Thanks for your help as always!

Steven

I would like to find out what is happening, it is strange, the only difference is the Glade file, could you post the plasmac_run_tab.glade file.
Could you also check if the Config and Statistics Panels are populated.

I've attached the file.

Yes, the Config and Statistics panels have always populated (even when the run panel did not).

Also, if it matters: If I remove the OPEN_FILE = "" in the [DISPLAY] section, I get the same error again. Removing the CYCLE_TIME = 0.1 does not seem to generate an error.

Having an open file tries to run the GCode parser before the panels are loaded so that is expected behaviour.
If you don't have cycle time then you may have trouble with the mouse clicks in the file explorer when you are opening a file.