RS485 For Hypertherms

I deleted the last one because it was definitely wrong, so give this one a try.

Rename ~/linuxcnc-dev/configs/by_machine/plasmac/plasmac_run.py to keep as a backup

Copy this new plasmac_run.py to ~/linuxcnc-dev/configs/by_machine/plasmac/

See how it goes.

phillc54 wrote: I deleted the last one because it was definitely wrong, so give this one a try.

Rename ~/linuxcnc-dev/configs/by_machine/plasmac/plasmac_run.py to keep as a backup

Copy this new plasmac_run.py to ~/linuxcnc-dev/configs/by_machine/plasmac/

See how it goes.

Works great! Everything seems to work exactly as it should (or at least how I expect it to)!

I like how the gas defaults to 0 between modes. Good touch.

Up to 32 ounces (or one quart) now I guess! :laugh:

Thanks for taking the time to get this polished up! Much appreciated and I am sure many will benefit from it.

Cool, I knew we would get there eventually. Thanks for testing.

@Phill,
I wanted to click on thank you and thought i'd check how many of them you've got, IT prevented me from clicking !

tommylight wrote: @Phill,
I wanted to click on thank you and thought i'd check how many of them you've got, IT prevented me from clicking !

HaHa, thanks Tom. I just checked and it is the devils number... :evil:

phillc54 wrote:

tommylight wrote: @Phill,
I wanted to click on thank you and thought i'd check how many of them you've got, IT prevented me from clicking !

HaHa, thanks Tom. I just checked and it is the devils number... :evil:

I did say IT prevented me.... Easter time, maybe he is lurking to find something sweet to bite.

tommylight wrote:

phillc54 wrote:

tommylight wrote: @Phill,
I wanted to click on thank you and thought i'd check how many of them you've got, IT prevented me from clicking !

HaHa, thanks Tom. I just checked and it is the devils number... :evil:

I did say IT prevented me.... Easter time, maybe he is lurking to find something sweet to bite.

If it is dark chocolate then I am in.

phillc54 wrote: Cool, I knew we would get there eventually. Thanks for testing.

Always happy to do testing; I enjoy it.

I could ship you some Hershey's dark chocolate... :laugh: I live pretty close to Chocolate World.

Ghirardelli is good.

so, I just noticed that the diagram for the location of pin 1 on the hypertherm in the user guide is different than what I see at my machine.

Pics attached. I couldnt find anything on hypertherm's end to verify.

Inside is with the connector pulled out of the machine. it's actually upside down in this pic (green is at the bottom). Also, I never messed with these, it's how it came pre wired from the factory.

outside obv shows my setup, with ground in pin 5 (at the bottom).