PlasmaC not updating

phillc54 wrote: I updated my local version from the buildbot this morning and it shows v0.146

Ok I suppose there is more than one server around the world.

I will give it 24-hours and try again thanks for the info

I think there is only the one.

Have you definitely got the buildbot in your sources list?

phillc54 wrote: I think there is only the one.

Have you definitely got the buildbot in your sources list?

Not sure about that. I use Beagles iso so also not sure if it goes through his. Server I had the impression that he updates it once a week.

I haven't done anything different then what I have done many times before. I don't recall seeing a sources list.

Beagles ISO gets the updates from Australia, so you might want to change that to local GB ones.

They would be slow coming from here, it's all uphill.

tommylight wrote: Beagles ISO gets the updates from Australia, so you might want to change that to local GB ones.

Where would i change that.

I have a none Beagle iso that is 2.9 and that one updated to V0.246

But the Beagle 2.8 did not so yes I might have to wait.

phillc54 wrote: They would be slow coming from here, it's all uphill.

Very funny :laugh:

Clive S wrote:

tommylight wrote: Beagles ISO gets the updates from Australia, so you might want to change that to local GB ones.

Where would i change that.

I have a none Beagle iso that is 2.9 and that one updated to V0.246

But the Beagle 2.8 did not so yes I might have to wait.

Debian is /etc/apt/sources.list and files in /etc/apt/sources.list.d I assume the Debian offshoots are similar.

phillc54 wrote:

Clive S wrote:

tommylight wrote: Beagles ISO gets the updates from Australia, so you might want to change that to local GB ones.

Where would i change that.

I have a none Beagle iso that is 2.9 and that one updated to V0.246

But the Beagle 2.8 did not so yes I might have to wait.

Debian is /etc/apt/sources.list and files in /etc/apt/sources.list.d I assume the Debian offshoots are similar.

I am not sure I understand this enough to play with it.:

You may have to check with beaglebrainz, it seems he builds the LinuxCNC packages for this distro. Maybe he hasn't updated.