Recent PlasmaC Update and No Motion

You may be better off starting a new thread in the stepconf section of the forum, a lot of folk probably won't notice your issues because this is in the plasmac section: forum.linuxcnc.org/16-stepconf-wizard

I think you should start a new configuration because you need to get these issues sorted out before add the plasmac configuration to your config.

Hi team,

I have the same issue:

command (EMC_SPINDLE_OFF) cannot be executed until the machine is out of E-stop and turned on

I'm using gmoccapy in a milling machine (no plasma cutter).

I'm totally stuck with this since many days. There's no info about it.
The only info I got surfing the web was:
emc.hh File Reference

I can't figure it out what is happening.
Any idea?

Thanks