No Arc after first cut

Hi all, recently got my machine going with plasmac and using a MESA THC card. My problem is when it finishes a cut it faults with no arc right at the very end of that cut.
During that first cut THC moves Z axis and controls the height. Any help would be appreciated, thanks.

.

If it similar to:
forum.linuxcnc.org/plasmac/40536-losing-arc-on-holes#188491
or:
forum.linuxcnc.org/plasmac/40308-some-th...smac?start=50#188257

I have just pushed a fix.

From the docs:
Some plasmac machines may lose the Arc OK signal momentarily during a cut causing PlasmaC to go into a lost arc error. There is a HAL pin to enable a delay time which will prevent a short Arc OK loss such as this. The pin is named plasmac.arc-lost-delay and this pin sets the amount of time (in seconds) PlasmaC will wait after losing the arc during a cut until it extinguishes the Arc OK signal and displays an error message. The following code would set a delay of 0.1 seconds. The recommended place to put this code is in the <machine_name>_connections.hal file.
This setting should only be used if the plasma machine exhibits the above symptoms.

Hi thanks for the help. When I paste it on that file I get the attached error.

Might have to wait for the buildbot to update then do a dist-upgrade