Help install "QtPlasmac" !!

If you have a working Axis config thent here are two methods to migrate to QtPlasmaC shown here:

linuxcnc.org/docs/devel/html/plasma/qtpl...tml#qt_modify-config

these are some screenshots,
please you can help me with fee?
because its almost the best solution.
i will send you remote access data..ok?
thank you

please you can help me with fee?
because its almost the best solution.
i will send you remote access data..ok?
thank you

I get the same as the first pic, I don't think that is an issue.

The second pic can be fixed by following this page:

buildbot.linuxcnc.org/

Use the stanzas at the top of the first table.

Running a config from the /tmp/ folder, why ?
Copy the config to the configs folder then try again:
/home/USER_NAME/linuxcnc/configs/