Errors after PlasmaC start and load file *.ngc

Friends, good day!

1. When launching LinuxCNC, the system reports that there is no GTKSourceView2 module. Where to take it and how to install it?


2. When you try to open a file with the NGC extension, an error "plasma_run.cut-type" appears. How to fix it?

I will add the INI and HAL files

forum.linuxcnc.org/9-installing-linuxcnc...debian-buster#158841

Thank you! Took the package at this address: packages.debian.org/stretch/python-gtksourceview2