wrong scale thc of the z axis during cutting on qtplasmac

More
5 years 3 months ago #213851 by sibista
wrong scale thc of the z axis during cutting on qtplasmac was created by sibista
 

Attachment not found

 

Attachment not found


Hello 
Error in the scale of the z axis when cutting with thc.  The values ​​are very small at 0.001 mm.  In the example, the torch rises 0.024 mm. While cutting on plasmac the thc torch is operating normally.  Version of qtplasmac v1.0.48

greetings

thc proma 150

Please Log in to join the conversation.

More
5 years 3 months ago #213921 by tommylight
Replied by tommylight on topic wrong scale thc of the z axis during cutting on qtplasmac
You mean the probe and pierce height, right ?

Please Log in to join the conversation.

More
5 years 3 months ago #213937 by sibista
Replied by sibista on topic wrong scale thc of the z axis during cutting on qtplasmac
no, while thc tells the torch to go up or down, the torch moves up and down but only in hundreds of millimeters, not even a millimeter will go up or down. sorry for english greetings

Please Log in to join the conversation.

More
5 years 3 months ago #213938 by sibista
Replied by sibista on topic wrong scale thc of the z axis during cutting on qtplasmac

Please Log in to join the conversation.

More
5 years 3 months ago #213939 by phillc54
Replied by phillc54 on topic wrong scale thc of the z axis during cutting on qtplasmac
Have you tried increasing the THC Speed %

 

Attachment not found



Edit: It also depends on MOTION Setup Speed in the PARAMETERS tab.

Please Log in to join the conversation.

More
5 years 3 months ago #213942 by sibista
Replied by sibista on topic wrong scale thc of the z axis during cutting on qtplasmac
yes, even up to 1000, nothing was done

Please Log in to join the conversation.

More
5 years 3 months ago #213943 by phillc54
Replied by phillc54 on topic wrong scale thc of the z axis during cutting on qtplasmac
What is the value of Setup Speed?

Can you post a backup of your config.

Please Log in to join the conversation.

More
5 years 3 months ago #213945 by sibista
Replied by sibista on topic wrong scale thc of the z axis during cutting on qtplasmac
Yes, later, now I can't. When I am at the machine I will do it. Greetings

Please Log in to join the conversation.

More
5 years 3 months ago #213959 by tommylight
Replied by tommylight on topic wrong scale thc of the z axis during cutting on qtplasmac
Missing
Plasmac.thc.feed-rate ?
I have it posted here on the forum somewhere but am on the phone.

Please Log in to join the conversation.

More
5 years 3 months ago #214366 by sibista
Replied by sibista on topic wrong scale thc of the z axis during cutting on qtplasmac
Hello
Where can i find it?

Please Log in to join the conversation.

Time to create page: 0.165 seconds
Powered by Kunena Forum