wrong scale thc of the z axis during cutting on qtplasmac

Hi
The move up and move down pins work, the led up and mi led down pins do not change. Pin thc-feet-rate has a value of 1425. I'll check with a real cut.


That seems normal, you won't get Z motion without the torch being enabled.

Before, my simulation worked and there was a movement of the Z axis. I turned on the burner and now it is ok. I do not know why it did not work before the Z-axis body. I reconfigured everything from scratch, I switched to English and everything is ok. Now I will go back to Polish and see if it works. Thanks for the help.

It may be an issue with decimals, does Polish use commas as decimal separators?
 

Everything works as it should.

Thanks a lot.
In Poland, a comma is used as a decimal separator.
regards