If you are using the halui plus and minus pins for jogging then you could probably just parallel them with the external cut recovery pins similar to:
Code:
net xPlusJog your_right_button_pin => halui.axis.x.plus qtplasmac.ext_cutrec_e
net xMinusJog your_left_button_pin => halui.axis.x.minus qtplasmac.ext_cutrec_w
net yPlusJog your_up_button_pin => halui.axis.y.plus qtplasmac.ext_cutrec_n
net yMinusJog your_down_button_pin => halui.axis.y.minus qtplasmac.ext_cutrec_s
It would restrict your to only the n, s, e, & w cut recovery buttons but should work ok.
