I understand that PB vertical may not be quite ready for prime time, but I'd like to try it out. I'm in the early phase of designing a new operator panel and switching to a vertical layout GUI would make thing much more tidy. I've not sorted out what monitor size I want as it's hard to get a feel for it just from screenshots.
Unfortunately, Ive no clue how to 'switch' from regular PB to Vertical. The only thing that shows up in my launcher is PB and the other qtpyvcp sims; no PB-lathe or PB-vertical. And since I'm using a RIP config, I dont use the launcher anyway except to look at GUIs.
I can open PB-vertical in Designer... just not sure how to make it load like the regular PB horizontal version.
Currently running MX21, Lcnc 2.9 RIP, qtpyvcp master and PB master.
Anyone want to walk me through loading PB vertical?
Thx,
Ralph
