probe basic dro scales in inces instead mm

Hi,

I am trying to setup my mill and i have something stage going on.
my dro gives me different values than halui.
When I use the jog function 1mm my mill moves one mm. the dro on hand wheel says 1mm.
the dro of probe basic 0.0394. so 1/25,4 inches
is there a setting for probe basic to switch between imperial and metric units?

Thanks Patrick

I think PB gets the DRO units from INI, but I noticed this:

forum.linuxcnc.org/qtpyvcp/48401-py3-pro...-doc-lcnc-2-9#287437

When I was poking around.  Maybe check your RS274 startup values?

yes it was in the RS274 values. didn't think about checking them.

Many thanks