qtvcp issues

hottabich wrote: Hello! Happy New Year everyone! I decided to make Qtpyvcp interface for linuxcnc. Based on Brender + mill_touch_v6 + probe_basic. Neither can I fix one error. Please help someone who can and if it's not difficult. Files are attached. Thank you in advance.
Скачать

Check the spelling.

Mill in the bottom error line only has one L. It's not finding that file it would seem

Please use the forum to attach files, not those web sites as they very often have all kinds of trackers/spies.

Happy New year!.
Unfortunately your code is using qtpyvcp and this thread is for qtvcp.
They are different code bases.
Please switch to another thread to avoid confusion.
Thanks

Chris M

Sorry, sorry.

Leon82 wrote:

hottabich wrote: Hello! Happy New Year everyone! I decided to make Qtpyvcp interface for linuxcnc. Based on Brender + mill_touch_v6 + probe_basic. Neither can I fix one error. Please help someone who can and if it's not difficult. Files are attached. Thank you in advance.
Скачать

Check the spelling.

Mill in the bottom error line only has one L. It's not finding that file it would seem

Thanks a little hurried, but two L does not help. In this thread, the question closes. Request to the moderator to delete my posts.

after installing qtpyvcp I can´t find the sim files in ~/linuxcnc/configs/sim.qtpyvcp

I´m using Debian GNU/Linux 9.11 (stretch) and Linux 2.9

Any suggestions?

qtpyvcp and qtvcp are not the same thing.
Please move your question to a thread specific to qtpyvcp.
Thanks
Chris

Hi
Does QtVCP runs in raspberry pi 4?
Anybody know how to install the develop version on raspberry pi?

thanks

I don't for sure know - pi3 had some problems.

Chris

I think Gene has a version for the Pi4.
Mesa has a board for them so it can be done
I have to say I was really surprised how nice the 4 is! (but not using for linuxcnc)