PyQt5 Ubuntu 20

Hi guys,

has any of you successfully installed PyQt5 to get qtvcp working on Ubuntu 20?

I guess there are obstacles when I found this thread related to Mint 20
forum.linuxcnc.org/qtvcp/40213-can-t-get...-start-with-qtdragon

Is there any improvement in this matter.

Thank you for answer
Jiri

Mint 20 requires linuxcnc to be compiled with python3 support.
I haven't tried Ubuntu 20.04 but since mint 20 is based on it - it might also require it.
Python 3 support I would call experimental yet.

I did have a successful install when 20 was beta aaaand never again, once i had about 6 versions of Python installed and it still did not work! Gave up and moved back to 19.3.

Alright, thanks. I guess I will also step down to previous version.