CMM to tooltable

I have just rigged up a spare QCTP to my small Mitutoyo CMM to measure all my lathe tools.

Easier to do it this way than test cutting and wasting material and lot of time.

Cheers
Bengt

Cool, but did you abandon the lathe touch probe project?

forum.linuxcnc.org/26-turning/34471-toolprobe-for-x-z-touch-off

For time being yes, it is on hold until I can get more knowledge on how to incorporate this to gmoccapy.

I have also a solution with arm but it is not so easy mechanically to adapt in my lathe.