Manncorp ECM93 Pick and Place

Might just be a random failure. Not sure what you could have done to the RS-422 interface, its pretty rugged.

Do I also need to file the RMA board repair in the miscellaneous section on the Mesa store?

No, that's not necessary

Dropped off the box at post office Should see it sometime this coming week week.

IT'S ALIVE! AH HA HA HA.
A special thanks to PCW and Mesa Electronics for diagnosing, repairing, and returning
the board so quickly. Plus a New 7i71 found it's way into the return box . Now I can leave the one on the
PnP project and have one connected to my computer at my house so I can learn how
to get the feeder program  working when I am at home as well. Theirs' so much to do.
Looks like it's time to get to work.

  After feeling like I have been beating my head against a wall getting Classic Ladder to do what I needed , it looks like I
FINALLY have a working feeder system. I will post a video of it working this next week.
  Basically I use M64 P## to advance the feeder and M65 P## to reset for the next feeder. Below are the current codes
I am using. I hope to have a better system setup in the future using hal components and using M1## codes instead.

 

 

As promised the video of the system working . I only had enough time to shoot video of it working and briefly explaining 
what it's doing. I will go more in depth in upcoming video's. Another step closer


 

 I am back at it again. LOL. Apparently this new years resolution is to finish the PnP controller.
No video's today but I did take a few pics of today's progress.







 

A few more pics of the progress.  It definitely takes a while when you're building a controller for a PnP, a router, and a side mill.

the PnP
 


the router and side mill internals
 

well as usual work has been very heavy keeping me from working on the PnP. I have however bought a more
powerful computer ( Dell OptiPlex 9020 SFF ) for it before shipping prices become insane.