Upgrade to PP 2.24

Hello,

I upgraded my lathe to Pathpilot 2.24, when I start the spindle does not start.
Gives me this error: " RPM must be between 0 and 0 in present spindle config" .
Where is the spindle speed configured?
On Pathpilot 2.16 I didn't have this problem.

Thanks for every suggestion

Sorry I can't answer that. But would you mind pointing me to where I could get a copy. I'm not sure what I should buy on their web site?

Thanks

can you post of screen capture of the screen while its displaying the error?

go here and purchase
www.tormach.com/store/index.php?app=ecom&ns=prodshow&ref=38249

I solved
It was due to [SPINDLE_9] in the .ini file and hal
I solved by correcting in [SPINDLE]

Thanks

Thanks for the reply I really appreciate it. Does this upgrade look for a previous version of PP to proceed or can I do a clean install for the USB?



Thanks Again - ed