MTconnect adapter for Tormach 440
- Kushagra
- Offline
- New Member
Less
More
- Posts: 2
- Thank you received: 0
26 Nov 2019 22:15 #151320
by Kushagra
MTconnect adapter for Tormach 440 was created by Kushagra
Hello everyone,
I am trying to develop an MTconnect adapter for Tormach 440 for which I need to import linuxcnc file from pathpilot.
But when I am entering Import linuxcnc on pathpilot terminal, It shows " no module found".
Can anyone please guide me on how should I proceed.
I am trying to develop an MTconnect adapter for Tormach 440 for which I need to import linuxcnc file from pathpilot.
But when I am entering Import linuxcnc on pathpilot terminal, It shows " no module found".
Can anyone please guide me on how should I proceed.
Please Log in or Create an account to join the conversation.
- smgvbest
- Offline
- Elite Member
Less
More
- Posts: 311
- Thank you received: 51
27 Nov 2019 01:55 #151329
by smgvbest
Replied by smgvbest on topic MTconnect adapter for Tormach 440
If you're trying to run python from the operator terminal window you need to run the rip_enviroment.sh from the ~/tmc/script directory to setup the terminal correctly. PP does this when started. then you can import linuxcnc
Please Log in or Create an account to join the conversation.
Time to create page: 0.045 seconds