Definitive guide to installing MX Linux, Probe Basic and LinuxCNC 2.9

According to this post it should be possible to just ask probe basic to not check for qtpyvcp version so my version number hack should not be needed anymore.

I'll modify my guide in case that turns out to be true.

Just followed the process for a clean install and got the following message

$ qtpyvcp -v
Traceback (most recent call last):
  File "/home/dave/.local/bin/qtpyvcp", line 33, in <module>
    sys.exit(load_entry_point('qtpyvcp', 'console_scripts', 'qtpyvcp')())
  File "/home/dave/qtpyvcp/qtpyvcp/app/__init__.py", line 72, in main
    from qtpyvcp.utilities.opt_parser import parse_opts
  File "/home/dave/qtpyvcp/qtpyvcp/utilities/opt_parser.py", line 64, in <module>
    from linuxcnc import ini
ImportError: cannot import name 'ini' from 'linuxcnc' (unknown location)

Any ideas?

I got the same message. Pasting the source command he put at the end of the instructions fixed it:

If you get unable to import ini from linuxcnc
    source ~/linuxcnc-dev/scripts/rip-environment

I still get the same error every time I run editvcp from terminal, but pasting the same thing clear it up.  I'll have to work out why it isn't persistent, but I've got about four thousand other things to sort out before I circle back to that issue.

Help!  I'm doing something wrong but can't figure out what.  I've gone thru the complete process of installing MX 21, linuxcnc 2.9 and probe basic three times now using the guide.

Probe basic opens fine and communicates with my mesa 7i95 card.  I can jog all the axis and home the mill but that's it.  None of the other subroutines, like loading a tool, work?

Thanks in advance for any ideas of where I went wrong.

If PB installed and can communicate with your LCNC & Mesa, you might want to start a new thread specific to your issue and not a continuation of the installation thread.

Having said that, exactly what isn't working?  When you say "loading a tool", do you mean an ATC?
 

Yeah, you might be right about starting a new thread.  I just think it might be something I'm doing wrong in the installation.

By loading a tool, I mean on the tools page, type in a tool number and hit load spindle and have it load the tool length.  Or on the main page type in a tool number and have the machine move to my tool change position.  Nothing happens when I try to do that.  I think it's not finding the subroutines for some reason.

I had a debian 9, linuxcnc 2.8 and probe basic setup working great except for the jogging speed issue on my 4th axis.  So I thought I would upgrade to get that fixed.  But, I can't get probe basic working.  I'm very new at linux and git.