Qtdragon occasionally overwriting preferences

Thanks @tommylight, I’ll see if having the Mesa board off will cause this issue.

You say it ignores the file. How do you know this?
Can you confirm that at shutdown the settings are written properly?

Ignoring vrs corrupted vrs not found is all clues to the problem, so it matters.

My guess is a closing problem that erases but doesn't write the file properly or the OS caching the file and it not getting written properly.

I guess I should have said it "appears to ignore the file". I'm going to try and pay better attention and check the timestamp/content of the pref file next time this happens while Linuxcnc is still running...unfortunately that's the problem with running in openbox, I always forget I can switch to a console and end up quitting linuxcnc to launch an xterm. I wish I knew how to trigger it, for a while I thought the problem disappeared through one of the fixes you have pushed out recently.

@cmorley I had the issue occur today and I remembered to switch over to a terminal to check the pref file. Basically Qtdragon started and reverted to default preferences while the old preferences file was present. The file had the time signature of the last time I shutdown Linuxcnc and the machine but Qtdragon just seemed to ignore it and loaded the defaults. Of couse after quitting, these defaults ended up overriding the appropriately configured preferences file.

@cmorely do you know the starting point in the qtvcp library for initializing preferences? I've tried a brute force technique to figure this out(as in where do the preferences get initialized and loaded) but I couldn't figure it out.