X,Y,Z,A axis OK.How config. "C" axis ?

Dear Gerd!!
All is perfect and working!
Very, Very Thanks for Your help to me!!!
Ciao a presto,
Kind Regards!
Luciano

Hello,

I am also a new user, trying to grasp the same basic concepts. I am trying to implement a n XZC axis configuration on what would be a lathe, using axis C in place of a spindle motor. If I read this post correctly, in EMC I would have to configure unused axis A and B to be able to configure axis C?

m8298 wrote:

If I read this post correctly, in EMC I would have to configure unused axis A and B to be able to configure axis C?

From my experience, I would say yes, but I would appreciate a comment of an EMC insider.

- Gerd

Hello m 8298!
I'm working with this configuration:
Axis X,Y,Z,A,B(not used),C used.
All is perfectly working.
I think you have to configure A,B and no use those for work with C axis.
Pratically i have the same condition.
Kind Regards,
Banda

Can you show me your Hal and .ini file?