Problem monitor linuxcnc.

Start
Prev
1
Next
End

jlviloria
Offline
Platinum Member

19 May 2013 04:11 #34353 by jlviloria

Problem monitor linuxcnc. was created by jlviloria

I'm working on a custom GUI, based on GScreen. but I need my monitor to allow rotation. but I get a message of "rotation not supported" I tried to install video drivers but my LinuxCNC not open with them installed. I can do?

thanks,

Jorge Viloria

Please Log in or Create an account to join the conversation.

Start
Prev
1
Next
End

Time to create page: 0.373 seconds