Moschip MCS9815CV + BAR error updating

Hallo,
i have installed LinuxCNC with the LiveCD.
Motherboard: Asus a8nsli

On one PCI slot i plugged in a Deloc dual lpt card. The chip on the card is the: Moschip MCS9815CV
When i start my computer i get following message:
[0.193621] pci 000:05:08: BAR 0 error updating (0x40000008 != 0x000048)
and this for BAR0 to BAR5 wit different adresses.
Afterwards:
modprobe: can´t load module micorcode(kernle/arch/x86/kernle/microcode.ko): No such device

After booting i startet: lspci -v

but the pci i device was not listed.
Non class device
And the memory ???

Can anybody help me?
I don´t know what to do.
Thank you very much

Hi

i have installed LinuxCNC with the LiveCD.

Which Live CD? There is the Ubuntu 10.04 one and the Debian Wheezy one

modprobe: can´t load module micorcode(kernle/arch/x86/kernle/microcode.ko): No such device

Look in /lib/modules/{kernel number}/kernel/arch/x86/kernel/

Is microcode.ko really missing?

It rather sounds more like an error with your computer or the card.

Try moving the card to another PCI slot, do you get the same error?

regards

HI.
You where right.
The problem is the pci controller on the mainboard.
Thank you for your help.