New PC needed

Start
Prev
1
Next
End

RoberCNC
Offline
Elite Member

01 Dec 2019 19:09 #151684 by RoberCNC

New PC needed was created by RoberCNC

Hi mates, my old PC is giving me problems and I think the time has come to go thinking about changing it.
What do you recommend for a Mesa 5i25 card, a second-hand Dell that I have seen so well that you speak or an Asrock-type embedded system motherboard that I have also seen here?

Please Log in or Create an account to join the conversation.

tommylight
Away
Moderator

01 Dec 2019 22:25 #151707 by tommylight

Replied by tommylight on topic New PC needed

A few days back i got two Fujitsu PC's
A fujitsu esprimo p700 e90+ tower with 4 core i5
and
A fujitsu esprimo p710 e85+ SFF with 2 core i3
Both have very good latency, even with Preempt-RT kernel it is in the 20000 range.
At 80 and 70 euro a piece respectively, very nice indeed !

Please Log in or Create an account to join the conversation.

RoberCNC
Offline
Elite Member

02 Dec 2019 08:10 - 02 Dec 2019 08:32 #151734 by RoberCNC

Replied by RoberCNC on topic New PC needed

My question especially is about the graphics and reliability, I do not want to have the conflict problems I had with this PC. As for latency, I can afford more of these 20,000 I understand, since I would connect the Mesa cards that I had to buy and still own (5i25 + 7i76).

It was going to be intended for the milling machine only, running linuxcnc and little else.

Last edit: 02 Dec 2019 08:32 by RoberCNC.

Please Log in or Create an account to join the conversation.

Start
Prev
1
Next
End

Time to create page: 0.079 seconds