New motherboard w/o parallel port...

so in my EMC2 .hal file, where it says, "loadrt hal_parport cfg="0x378 out "

should I change that to match this line:

I/O ports at dd00

In other words, the "0x378 out" should be "dd00" right?

shotgunn

so how do I load the driver? I thought that was what I was trying to do?

SWEET!!!! I just changed the "0x378 out" to "dd00"

I'm ALL GOOD!!!!

THanx a million!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

shotgunn



PCW wrote:

>>how do I change it though?

You cannot change it.

>>shouldn't it NOT say 'unknown device' Why does it say that?

Because there is no driver loaded for that device For NetMos I think this is OK

>> when I try running that command it says bash: loadrt: command not found"

Thats because the loadrt command belongs in the HAL file, not the command line...

Thats right, 0xdd00 or possibly 0xdc00