Reading value of pin in g code

Hi, I want to make if loop and don't know how to write it properly. The task is: if state of coil1 (in classicladder) is 1 then make something. Coil1 is assigned to pin P01.

I tried with: or simple
I got this error:

Unknown word where unary operation could be

There are a number of issues here.

Firstly, to check for equality in G-code you have to use "EQ"

O100 IF [#124 EQ 100]
Do Stuff
O100 ENDIF

linuxcnc.org/docs/2.7/html/gcode/overvie...ode:binary-operators

It is possible to read HAL pins in G-code, but the feature needs to be turned-on.
linuxcnc.org/docs/2.7/html/remap/remap.h...i_file_configuration

I wouldn't recommend doing that in this case, though. The problem is that the values are read at preview-time, not at run-time. This could cause unexpected results.

Much better to "net" the classicladder pin to one of the G-code digital input pins and use M66 to read it.
linuxcnc.org/docs/2.7/html/gcode/m-code.html#mcode:m66

I knew this comands, but i can't use it properly. While loop is working well.
My unfortunately bad ideas ....

also try with GOTO.. here is one of my bad codes.. and there is an error:

bad character n used

Radek wrote: I knew this comands, but i can't use it properly.

The key is the phrase "The current value of the input is stored in parameter #5399"

Though normally you don't need to check the value as you use it in a "wait for state" mode and just need to check for timeout.

Ok, but now i want to back to 1st line of programme. What command should i use? GOTO ?

Ok... shit happens.. it's not working

Radek wrote: Ok, but now i want to back to 1st line of programme. What command should i use? GOTO ?

Do you want it to run for ever?

There is no GOTO in G-code:
linuxcnc.org/docs/2.7/html/gcode/o-code.html