G2 on X,Y and Z

More
24 Sep 2010 14:37 #4313 by eddycnc
G2 on X,Y and Z was created by eddycnc
Hi,
I've a question about G2 command.
I need to know if is possible to create an arc on X,Y but at the same time go down with Z axis
how can i do that?

Please Log in or Create an account to join the conversation.

More
24 Sep 2010 16:30 - 24 Sep 2010 17:01 #4314 by radekB
Replied by radekB on topic Re:G2 on X,Y and Z
G00 G17 G90 G21
G00 X10 Y0
Z0
G02 X10 Y0 I-10 J0 Z-5 F500
G02 X10 Y0 I-10 J0 Z-10
G1 X0 Y0
G0 Z25
M2

RADEK
Last edit: 24 Sep 2010 17:01 by radekB.

Please Log in or Create an account to join the conversation.

More
24 Sep 2010 23:16 #4325 by BigJohnT

Please Log in or Create an account to join the conversation.

Time to create page: 0.090 seconds
Powered by Kunena Forum