Why is Stepgen not outputting a steady stream of pulses with a constant velocity

24 Apr 2017 13:46 #91961 by tecno

Why is Stepgen not outputting a steady stream of pulses with a constant velocity was created by tecno

Moving my question here from: forum.linuxcnc.org/16-stepconf-wizard/32...nd-stepconfig-issues

I am getting pulsating signal on pin 6 to my step/voltage converter to control my VFD.
hal file here forum.linuxcnc.org/media/kunena/attachme...C3000_2017-04-24.hal

Anybody out there that can have a look at this odd behavior. Have been running Mach3 with no such issues.

Cheers
Bengt

Please Log in or Create an account to join the conversation.

Time to create page: 0.075 seconds