Tormach 15L Slant-PRO CNC Lathe
21 Jun 2016 15:37 #76348
by fc60
Tormach 15L Slant-PRO CNC Lathe was created by fc60
Greetings,
I was reading about this lathe on the Tormach website.
www.tormach.com/product_15l_slantpro.html#docs
It appears to run on some flavor of Linux.
Of course, the factory rep's will not confirm anything.
Anyone use one of these machines? If so, would you buy it again?
Cheers,
Dave
I was reading about this lathe on the Tormach website.
www.tormach.com/product_15l_slantpro.html#docs
It appears to run on some flavor of Linux.
Of course, the factory rep's will not confirm anything.
Anyone use one of these machines? If so, would you buy it again?
Cheers,
Dave
Please Log in or Create an account to join the conversation.
21 Jun 2016 19:11 #76365
by PCW
Replied by PCW on topic Tormach 15L Slant-PRO CNC Lathe
The SlantPRO runs a variant of LinuxCNC/Machinekit with a custom GUI (PathPilot)
You are likely to get a better response to your question from the Tormach forum on cnczone
You are likely to get a better response to your question from the Tormach forum on cnczone
The following user(s) said Thank You: fc60
Please Log in or Create an account to join the conversation.
Moderators: piasdom
Time to create page: 0.144 seconds