Sheetcam Turn / Lathe Module Development
- robertspark
- Offline
- Platinum Member
Less
More
- Posts: 915
- Thank you received: 216
28 Dec 2020 11:51 #193350
by robertspark
Sheetcam Turn / Lathe Module Development was created by robertspark
This may be of interest to Turn users or those that already use sheetcam to register your interest / preferences of what you desire
:https://forum.sheetcam.com/viewtopic.php?f=4&t=8459&p=28059#p28057
Ok, so its not LinuxCNC..... but it could help you out if you are a lathe user looking for a turn profiling application..... (I've struggled to find something I'm happy with with a post processor that is adaptable for whatever motion controller software I run [pathpilot+mesa hardware on its way now.... eagerly awaited!!!!]
If you have used a turning CAM, what did you like about it and what did you dislike? What turning strategies do you want to see?
:https://forum.sheetcam.com/viewtopic.php?f=4&t=8459&p=28059#p28057
Ok, so its not LinuxCNC..... but it could help you out if you are a lathe user looking for a turn profiling application..... (I've struggled to find something I'm happy with with a post processor that is adaptable for whatever motion controller software I run [pathpilot+mesa hardware on its way now.... eagerly awaited!!!!]
Please Log in or Create an account to join the conversation.
29 Dec 2020 04:24 #193399
by rodw
I knew you would weaken eventually! Keep us posted how you go with path pilot for plasma.
Replied by rodw on topic Sheetcam Turn / Lathe Module Development
[pathpilot+mesa hardware on its way now.... eagerly awaited!!!!]
I knew you would weaken eventually! Keep us posted how you go with path pilot for plasma.
Please Log in or Create an account to join the conversation.
- robertspark
- Offline
- Platinum Member
Less
More
- Posts: 915
- Thank you received: 216
29 Dec 2020 06:49 #193403
by robertspark
Replied by robertspark on topic Sheetcam Turn / Lathe Module Development
actually I got path pilot for my lathe.
I am going to give it a go for that and then see where it goes.
I am going to give it a go for that and then see where it goes.
Please Log in or Create an account to join the conversation.
Moderators: piasdom
Time to create page: 0.077 seconds