7i43 and USB firmware load

Hi!
I purchased 7I43U (only USB interface), connect to computer and tried to start hm2 examples.
But unfortunatly...
Only the message appears:
[ 2283.455958] hm2: loading Mesa HostMot2 driver version 0.15
[ 2283.460883] hm2_7i43: loading HostMot2 Mesa 7i43 driver version 0.3
[ 2283.462768] hm2_7i43: failed to clear EPP Timeout!
[ 2283.464771] hm2_7i43: /DONE is not low after CPLD reset!
[ 2283.465142] hm2_7i43.0: firmware: requesting hm2/7i43/SVST4_4B.BIT
[ 2283.469415] hm2_7i43: /DONE is not low after CPLD reset!
[ 2283.469431] hm2/hm2_7i43.0: failed to reset fpga, aborting hm2_register
[ 2283.469436] hm2_7i43.0: board at (ioaddr=0x0378, ioaddr_hi=0x0778, epp_wide ON) not found!
[ 2283.733940] hm2: unloading
It looks like that emc not understanf the USB...
The jumpers in 7i43 (W4, W5) set in USB configuration source...
How to start 7i43?

EMC does not support the USB interface of the 7I43, only the EPP interface
(the -U model can use the EPP interface as well)