PCI PIO BOARD
- CrazyPenguin
- Offline
- New Member
-
Less
More
- Posts: 12
- Thank you received: 0
06 May 2009 17:45 #214
by CrazyPenguin
PCI PIO BOARD was created by CrazyPenguin
Hello!!
Fisrt........ my english is not good.........
in my application I need a lot of digital I/O......... the question is: Is posible to install a generic pci pio board in the EMC2 ?
Fisrt........ my english is not good.........
in my application I need a lot of digital I/O......... the question is: Is posible to install a generic pci pio board in the EMC2 ?
Please Log in or Create an account to join the conversation.
06 May 2009 18:48 #215
by dfarrell
Replied by dfarrell on topic Re:PCI PIO BOARD
Did you look at the Mesa boards? www.mesanet.com These boards are already
supported.
supported.
Please Log in or Create an account to join the conversation.
06 May 2009 19:51 #216
by alex_joni
Replied by alex_joni on topic Re:PCI PIO BOARD
CrazyPenguin wrote:
Only if you write a HAL driver for it. (or there is one already).
Regards,
Alex
the question is: Is posible to install a generic pci pio board in the EMC2 ?
Only if you write a HAL driver for it. (or there is one already).
Regards,
Alex
Please Log in or Create an account to join the conversation.
- CrazyPenguin
- Offline
- New Member
-
Less
More
- Posts: 12
- Thank you received: 0
07 May 2009 23:42 #220
by CrazyPenguin
Replied by CrazyPenguin on topic Re:PCI PIO BOARD
Please Log in or Create an account to join the conversation.
10 May 2009 17:03 #233
by dfarrell
Replied by dfarrell on topic Re:PCI PIO BOARD
No doubt one could spend many hours building this board and writing a driver. Do yourself a
big favor and use a mesa board instead. If you do not require PCI performance there are
many more options. For low budget, search ebay, I'm sure many ISA boards are available
for cheap.
David.
big favor and use a mesa board instead. If you do not require PCI performance there are
many more options. For low budget, search ebay, I'm sure many ISA boards are available
for cheap.
David.
Please Log in or Create an account to join the conversation.
Time to create page: 0.086 seconds