need Mesa board recommendation
- johns00056
- Offline
- Premium Member
Less
More
- Posts: 108
- Thank you received: 2
17 Mar 2014 18:15 #44914
by johns00056
need Mesa board recommendation was created by johns00056
I am building a new mill.
I need 4 axis brushless servo motors. I have 8i20 brushless servo driver that I have tested and think I can get it to work without the hall signals, ( might want to add the hall commutation signals in the future)
MPG
4-home switches
spindle control and rigid tapping
remote e-stop
remote feed rate over ride potentiometer.
I have 5i25 and 7i85 daughter card now, and I have one servo motor pretty close to working.
I have come to find out that I need an additional card for the general purpose IO.
I am not opposed to abandoning what I have now and going a different route.
Maybe a combination of cards that works in the pncconf set up wizard would be better for me.
I need 4 axis brushless servo motors. I have 8i20 brushless servo driver that I have tested and think I can get it to work without the hall signals, ( might want to add the hall commutation signals in the future)
MPG
4-home switches
spindle control and rigid tapping
remote e-stop
remote feed rate over ride potentiometer.
I have 5i25 and 7i85 daughter card now, and I have one servo motor pretty close to working.
I have come to find out that I need an additional card for the general purpose IO.
I am not opposed to abandoning what I have now and going a different route.
Maybe a combination of cards that works in the pncconf set up wizard would be better for me.
Please Log in or Create an account to join the conversation.
18 Mar 2014 02:32 #44930
by emcPT
Replied by emcPT on topic need Mesa board recommendation
Maybe a 7i74 + 7i73.
I am using a 7i73 in a panel with good success.
I am using a 7i73 in a panel with good success.
Please Log in or Create an account to join the conversation.
Time to create page: 0.072 seconds