A mesa driver board - brain fumble.

So i have another thread, but think this will be more usefull in a seperate thread.

So basicly my setup look like this hardware wise now

1x 7.5kW VFD + Motor - gonna be used for spindle, this takes a 10V control voltage, that is controlled with a resistor today (for experiments)
3x Granite Devices Argon drivers + 3 Quadrature Chinese 1kW servo motors in a 130mm frame.
1x Compact Industrial grade 3.5" inch mainboard.

To control this im thinking of going
7i90HD or 7i80HD (not decided, ive got 2.7 running on my box anyway).
7i48 6 Channel analog service interface. - Here im thinking that this could drive the VFD as well?! No yes?
7i37-COM Isolated I/O card, this will be used for hardware interface buttons nothing else.

If i cant use the 7i48 for driving the VFD could i use
7i42TA and a SPINx1 PWM module for generating the 10V signal needed to tell the VFD what todo?

And in the end will this mumbo jumbo card setup work together. Im thinking it will - but just double checking, with shipping to sweden this will be quite the bigger investment than i thought. =)

I can specifically order a unit for you as normally I group "non usual" orders.

________________
www.eusurplus.com

You have an email .=)