Okuma servo drive.

03 Oct 2015 02:07 #63381 by timewarp

Okuma servo drive. was created by timewarp

Hi, has anyone been able to interface linuxcnc to an okuma bl2d servo drive?

Please Log in or Create an account to join the conversation.

03 Oct 2015 03:33 #63382 by timewarp

Replied by timewarp on topic Okuma servo drive.

Please Log in or Create an account to join the conversation.

03 Oct 2015 23:27 #63400 by aventtini

Replied by aventtini on topic Okuma servo drive.

i have seen it has SW1 and SW2 it works i think . The schematics are a little confused

Please Log in or Create an account to join the conversation.

Moderators: PCW, jmelson

Time to create page: 0.101 seconds