PiDiCNC Control System

They sent me a link to download the image and removed it promptly after i did.
That was very strange as it should be available, it is machinekit so open source.

my machinekit instance has no pidi no pidi found in machinekit repository
I guess I will do without it
Thanks tom

Hi mngr0,

I saw your message earlier but I'm busy these days. I will send you an image with preinstaled machinekit and pidi driver. I have a good news, this image have working opengl acceleration.

As Tom mentioned I sent him an image, but I did not delete it. I sent it over myairbridge.com where is restriction for free plan that they keep files only for 2 days

Viktor

Hi Vitkan,

Thank you for the offer, as I am writing a mesa-like firmware I am interested in the source code primarily. My objective is understanding how the hostmot2 communication goes.
Can you give it too?
Until now I tried looking both in the FPGA side and in the LinuxCNC side, but with no luck.
If you, or anyone, could help me with that I would really appreciate

Hi Mngr0,

First of all, our boards are not based on any Mesa boards or hostmot software. We inspired on driver from kinsamanka who made a driver which can communicate with his board over SPI.
I sending you source files, maybe could be helpful. It is only for Raspberry Pi and for communication over SPI

Has there been any progress on these boards?
Have you got a price yet?