MECHATROLINK-II interface

Hi Dmitry, sorry for my persistence in trying to contact you.
I am keen to buy one of your Yaskawa Sigma 7 Compatible boards.
I tried contacting you by email on the SSCNET email but have had no response as yet.
If you could check to see if my email got sidelined please.
Many thanks

Geoff

hello!
your email service is broken:
The recipient server did not accept our requests to connect. For more information, go to support.google.com/mail/answer/7720
[surfdyne.com 104.24.15.55: timed out]
[surfdyne.com 198.41.201.51: timed out]
[surfdyne.com 104.19.52.50: timed out]
a text message to the phone number and telegram did not work either. so.. get a working email please...

if your drives are M-II (SGD7S-xxxx10A with a couple of USB-A type connectors) then yes, YMTL2P will work

I sent a message to your email to purchase one of these boards.
my email - realeletric@realeletric.com.br

Hey,

I have Omron R88D-GN04H-ML2 drives in a three axes CNC pick and place setup. The drive takes the commands from Omron trajexia MC04/ML04 motion controller. I was hoping, I could control the servo drives from linuxcnc but found out about the mechatrolink-II network is the only available command interface to the drives. I would like to buy the FPGA hadware that you developed. May I contact you through personal email?

sure: yurtaev@gmail.com