MECHATROLINK-II interface
- REAL ELETRIC
- Offline
- New Member
-
Less
More
- Posts: 2
- Thank you received: 0
10 Mar 2025 00:47 #323582
by REAL ELETRIC
Replied by REAL ELETRIC on topic MECHATROLINK-II interface
I sent a message to your email to purchase one of these boards.
my email - This email address is being protected from spambots. You need JavaScript enabled to view it.
my email - This email address is being protected from spambots. You need JavaScript enabled to view it.
Please Log in or Create an account to join the conversation.
- pmchetan
- Offline
- Senior Member
-
Less
More
- Posts: 58
- Thank you received: 3
06 Nov 2025 09:38 #337957
by pmchetan
Replied by pmchetan on topic MECHATROLINK-II interface
Hey,
I have Omron R88D-GN04H-ML2 drives in a three axes CNC pick and place setup. The drive takes the commands from Omron trajexia MC04/ML04 motion controller. I was hoping, I could control the servo drives from linuxcnc but found out about the mechatrolink-II network is the only available command interface to the drives. I would like to buy the FPGA hadware that you developed. May I contact you through personal email?
I have Omron R88D-GN04H-ML2 drives in a three axes CNC pick and place setup. The drive takes the commands from Omron trajexia MC04/ML04 motion controller. I was hoping, I could control the servo drives from linuxcnc but found out about the mechatrolink-II network is the only available command interface to the drives. I would like to buy the FPGA hadware that you developed. May I contact you through personal email?
Please Log in or Create an account to join the conversation.
- dm17ry
-
- Offline
- Elite Member
-
Less
More
- Posts: 191
- Thank you received: 75
06 Nov 2025 14:39 #337975
by dm17ry
Replied by dm17ry on topic MECHATROLINK-II interface
sure: This email address is being protected from spambots. You need JavaScript enabled to view it.
Please Log in or Create an account to join the conversation.
Moderators: PCW, jmelson
Time to create page: 0.076 seconds