UC100 Motion Controller. Support

Start
Prev
1
Next
End

qcu87z
Offline
New Member

31 Dec 2015 01:43 #67575 by qcu87z

UC100 Motion Controller. Support was created by qcu87z

Morning all,

I was wondering if any one uses an UC100 with their CNC. I have a Stepcraft CNC mill that I use a UC100 with Mach3. It works well but I would like to run LinuxCNC rather than a Windows box as the windows machine was given up.

I hope this is the right sections to ask this question. I did a quick search on this forum and found no information about UC100's

Ash.

Please Log in or Create an account to join the conversation.

cmorley
Away
Moderator

31 Dec 2015 02:39 #67578 by cmorley

Replied by cmorley on topic UC100 Motion Controller. Support

seems to use USB - so no will not work with linuxcnc.

Chris M

Please Log in or Create an account to join the conversation.

andypugh
Offline
Moderator

31 Dec 2015 02:55 #67580 by andypugh

Replied by andypugh on topic UC100 Motion Controller. Support

It looks like quite a neat thing, in its way. But that _is_ a motion controller, and LinuxCNC is a motion controller.

LinuxCNC has never been modified to offload all motion control to external hardware. Possibly because it's not an interesting thing to do unless there is money in it...

Please Log in or Create an account to join the conversation.

qcu87z
Offline
New Member

31 Dec 2015 04:52 #67583 by qcu87z

Replied by qcu87z on topic UC100 Motion Controller. Support

Thanks for the information I will have to find something else to send the GCODE to the uc100

Cheers guys/girls

Please Log in or Create an account to join the conversation.

Start
Prev
1
Next
End

Moderators: PCW, jmelson

Time to create page: 0.059 seconds