Help with 7i77 Fwd & Reverse Pulse Train

More
10 years 3 months ago #77515 by PCW
Replied by PCW on topic Help with 7i77 Fwd & Reverse Pulse Train
If you don get both + and - voltage across A and /A , B and /B and Z and /Z (and never 0V)
you have a mis-connect or open signal

Code:
7I77 P3 DRIVE CN1A 1 A 6 2 /A 16 3 GND 10 4 B 7 5 /B 17 6 +5 NC 7 IDX 5 8 /IDX 15

Please Log in or Create an account to join the conversation.

More
10 years 3 months ago #77526 by sticky
Replied by sticky on topic Help with 7i77 Fwd & Reverse Pulse Train
I'm in! I have encoder Position and count on the Hal meter! I can even see movement on the preview window of linuxcnc when I turn the handle.

Unfortunately, i still have the joint access error whenever I try to move, however.

Please Log in or Create an account to join the conversation.

More
10 years 3 months ago #77528 by PCW
Replied by PCW on topic Help with 7i77 Fwd & Reverse Pulse Train
I think this thread hopped the tracks...
please put this in the Joint 0 following error thread

forum.linuxcnc.org/forum/38-general-linu...ollowing-error#77466

Please Log in or Create an account to join the conversation.

More
10 years 3 months ago #77529 by sticky
Replied by sticky on topic Help with 7i77 Fwd & Reverse Pulse Train
Sorry about that! I Have several windows open and accidentally posted to the wrong thread.

Please Log in or Create an account to join the conversation.

Moderators: PCW, jmelson
Time to create page: 0.260 seconds
Powered by Kunena Forum