Linuxcnc does not do raster engraving with mesa cads.
So i will take a chinese laser controller that outputs step dir and
3 dc brushed servo drives leadshine dcs810 that accept step dir to drive servos
Linuxcnc CAN do raster engraving provided the gcode.
It can do almost anything any other machine can do. It is a machine controller, not a CAD/CAM !
I use it for raster engraving on many machines as you can clearly see on the link above and on my youtube channel.
tommylight your engraving results are not good.
see this
www.sauno.ru/ENG/
It is hammering with needle.
Iam interested making a machine like this with linuxcnc.
Yes those look better if they are to be believed, but i have seen similar machines that did not even come close to what i get and they where about 4 to 5 times slower than mine. Mine do a full size picture (35x20cm) in 25 to 30 minutes.
No eBay APP ID and/or Cert ID defined in Kunena configurationNo eBay APP ID and/or Cert ID defined in Kunena configurationI have build a co2 laser with chinese controller and cheap glass tube
and am getting far more better results from that you get.
I think your results are unacceptable to be sold and iam saying that because i have sold over 50 portraits in granite.
30x40 portrait about 45mins.
Yes hammering is slow but sauno hammering machines are the best
and produce better results than other similar machines.
The bad of laser is that it needs totally black granite.
Hammering works and in not so black granite.
tommylight wrote: Linuxcnc CAN do raster engraving provided the gcode.
It can do almost anything any other machine can do. It is a machine controller, not a CAD/CAM !
I use it for raster engraving on many machines as you can clearly see on the link above and on my youtube channel.
How can i do raster engraving at constant speed with mesa card ?
