Wireing 7i76e with ihsv57

Hello, I have a few problems with the 7i76e.

I have this set up with the wizard and she is ready.


Now I have a servo connected.
TB2
Step0-> Servo Pulse
Step0 + -> Servo Pil +
Dir0-> Servo Dir-
Dir0 + -> Servo Dir +

P3
5V supply

The servo is in control mode but it does not seem to get any impulses.

The firmware is original and the juper are on default


does anyone have an idea?

is the drive enabled? (holds position)

Is the step pulse too short? (drive requires 2.5 us minimum so i would try 3-5 us to start)

Ahhh you are the best


Thank a lot