Bob Campbell break out board with linux?
- i_r_machinist
- Offline
- New Member
-
Less
More
- Posts: 9
- Thank you received: 0
01 Nov 2018 19:15 #119779
by i_r_machinist
Bob Campbell break out board with linux? was created by i_r_machinist
Hello,
Back in 2010 I retrofitted a 4 axis milling machine with Mach3, a Bob Campbell BOB, and viper 200 drives. I'm tired of fighting Windows. My question is, does anyone have experience running Linux with a Bob Campbell break out board? Can it be done?
Thanks
i_r_machinist
Back in 2010 I retrofitted a 4 axis milling machine with Mach3, a Bob Campbell BOB, and viper 200 drives. I'm tired of fighting Windows. My question is, does anyone have experience running Linux with a Bob Campbell break out board? Can it be done?
Thanks
i_r_machinist
Please Log in or Create an account to join the conversation.
- tommylight
-
- Away
- Moderator
-
Less
More
- Posts: 19413
- Thank you received: 6509
01 Nov 2018 19:57 - 01 Nov 2018 19:57 #119783
by tommylight
Replied by tommylight on topic Bob Campbell break out board with linux?
Both of them should work, just be sure to enable charge pump on pin 1 i think, if they use parallel port.
Last edit: 01 Nov 2018 19:57 by tommylight.
Please Log in or Create an account to join the conversation.
Moderators: PCW, jmelson
Time to create page: 0.110 seconds