allen bradley powerflex 40
29 Dec 2018 04:49 #123053
by vre
allen bradley powerflex 40 was created by vre
I have many vfd allen bradley powerflex 40 4kw 400v class.
Can i drive with these vfds servo motors
(3phase synchronous pm motors) with+-10v analog and send the encoder
feedback to linuxcnc?
Normally these vfds drive induction motors(asynchronous) but can drive synchronous? Manual does not say anything.
Says it supports V/F & sensorless vector control.
Can i drive with these vfds servo motors
(3phase synchronous pm motors) with+-10v analog and send the encoder
feedback to linuxcnc?
Normally these vfds drive induction motors(asynchronous) but can drive synchronous? Manual does not say anything.
Says it supports V/F & sensorless vector control.
Please Log in or Create an account to join the conversation.
29 Dec 2018 15:43 #123090
by pl7i92
Replied by pl7i92 on topic allen bradley powerflex 40
yes you can do this
by using the MESA 7i77 itt gives yoiu a very fast and good working mashine
with a 7i92 you can go full ethernet
by using the MESA 7i77 itt gives yoiu a very fast and good working mashine
with a 7i92 you can go full ethernet
Please Log in or Create an account to join the conversation.
Time to create page: 0.063 seconds