Bitsensor controller
- ionapostol@gmail.com
- Offline
- New Member
-
Less
More
- Posts: 2
- Thank you received: 0
13 Mar 2020 14:28 - 13 Mar 2020 14:29 #160020
by ionapostol@gmail.com
Bitsensor controller was created by ionapostol@gmail.com
Last edit: 13 Mar 2020 14:29 by ionapostol@gmail.com.
Please Log in or Create an account to join the conversation.
- andypugh
-
- Offline
- Moderator
-
Less
More
- Posts: 23310
- Thank you received: 4858
13 Mar 2020 16:16 #160038
by andypugh
Replied by andypugh on topic Bitsensor controller
Sorry, No. That's basically a complete motion controller that uses (a very small part of) Mach3 as the GUI.
On the plus side, there is no way that LinuxCNC could ever run that controller better than Mach does, so you are not losing out.
On the plus side, there is no way that LinuxCNC could ever run that controller better than Mach does, so you are not losing out.
Please Log in or Create an account to join the conversation.
- ionapostol@gmail.com
- Offline
- New Member
-
Less
More
- Posts: 2
- Thank you received: 0
13 Mar 2020 16:41 - 13 Mar 2020 16:42 #160046
by ionapostol@gmail.com
Replied by ionapostol@gmail.com on topic Bitsensor controller
Ok, thank you. I was thinking that I can use linux not windows which need licence.
Last edit: 13 Mar 2020 16:42 by ionapostol@gmail.com.
Please Log in or Create an account to join the conversation.
- andypugh
-
- Offline
- Moderator
-
Less
More
- Posts: 23310
- Thank you received: 4858
13 Mar 2020 16:44 #160047
by andypugh
Replied by andypugh on topic Bitsensor controller
Please Log in or Create an account to join the conversation.
Moderators: PCW, jmelson
Time to create page: 0.053 seconds