Mesa 7i97 setup problem

Can you tell me if 7i97 is supported in pncconf in LCNC 2.9.

bokito wrote: Can you tell me if 7i97 is supported in pncconf in LCNC 2.9.

No it is not, but it is !
There is no 7i97 in Pncconf, but there is 7i92 with 7i77, and that is basically the same thing, so create a config with those cards selected and save, open the ini file and change the name of the card, save.
Beware, for that to work, you have to select as in the screenshot on the second page of Pncconf

Hi tommylight,
I'm trying to setup 7i97 using pncconf and when I reach the mesa card configuration page 'MESA 0' I do not see an option for a single 7i77, only 7i77_7i76 is available. As per my understanding and your comments above mesa 7i97 is equivalent to 7i92+ one 7i77. So which Firmware option should I select? i have attached a picture for your reference.

7i77x2 with ON (should be ONE ) 7i77

Thanks will try it out.

Did you suceed? I tried the same, but using the given options, I can see P1 and P2 tab, but no obvious possibility to assign the analog outputs to the axis or spindle drive.

And then pncconf of course complains "no stepper or pwm signal assigned..."


Regards
Daniel