Teknic Clear Core Thoughts

I have a Clear Core from Teknic that I am looking to use with a raspberry pi 4 setup. Will drivers need to be created for this? There is an SPI interface that can communicate with the rPI, but will this be able to be configured through Linuxcnc properly? I am completely new to a lot of this, so any help be appreciated.

www.teknic.com/products/io-motion-contro...o-motion-controller/

I don't think those can be used with Linuxcnc.

And this is the second time you are asking for the same thing.

Sorry, it was not you.
Here is the original topic:
forum.linuxcnc.org/38-general-linuxcnc-q...nd-motion-controller

No problem. Thank you for the link. I tried a search but came up empty.